Install a replacement Infocus IN1126 projector lamp

How to install a replacement Infocus IN1126 projector lamp

Replace the Infocus IN11264 projector lamp quickly by following this  step-by-step guide.

Why go with authentic

Buy an authentic replacement projector lamp and avoid the headaches associated with counterfeit lamps. Find the 6 most common problems associated with counterfeits at the end of this post

Top reasons to avoid counterfeit lamps:

• inferior parts
• prone to explosions
• may end up costing due to shorter lamp life
• needlessly exposes you to toxic materials

Buy from a legitimate source to keep your projector under warranty and working properly.

Install the replacement projector lamp

Your InFocus IN1126 projector needs the InFocus SP-LAMP-076 replacement projector lamp. Follow these important safety steps BEFORE installing the replacement

• Turn off the InFocus IN1126 projector and unplug the power cord.
• To avoid getting burned, let the projector fully cool before changing the lamp.
• Do not operate the projectors while any of the lamps are removed as this may result in malfunctions, fire hazard and other accidents.

• Loosen the two captive screws on the lamp cover.
• Remove the lamp cover.
• Remove the two screws from the lamp module.
• Lift the module handle up. Pull firmly on the module handle to remove the lamp module.
• NOTE: The InFocus SP-LAMP-076 contains mercury and should not be thrown into regular garbage. Recycle this used lamp!

• Place the new lamp into the projector being sure to line it up properly. Align the lamp module with the connector and ensure it is level to avoid damage.
• Make sure the lamp is sitting securely in place and the lamp connector must be
• connected properly before tightening the screws.
• Tighten the two screws on the lamp.
• Replace the lamp cover and tighten the screws.

To reset the lamp timer:

• Press MENU
• Select INSTALLATION II/ ADVANCED. Press Enter
• Scroll down to select LAMP HOUR RESET. Press Enter
• Press the left arrow, then down arrow, then up arrow and double arrows
• Press the MENU button to get back to INSTALLATION II

Tips for longer lamp life

• Keep your air filters clean to avoid overheating the projector.
• Turn off the Infocus IN1126 and let it stand for at least one hour ever 24 hours.
• Make sure there is enough airflow around the projector particularly if it’s been permanently mounted.
• Top tips for extending DLP projector lamp life