Samsung HL-S4676S DLP just quit working!


Moderator: Angel

Forum rules
User avatar
Bufordhog02
Contributor
Contributor
Posts: 3
Joined: Tue May 11, 2010 4:13 pm
Location: Georgia

Samsung HL-S4676S DLP just quit working!

Postby Bufordhog02 » Tue May 11, 2010 9:46 pm

My HL-S4676S DLP just turned off while we were watching. I got a new lamp and installed it and still not working. I checked the plug receptacle on the board that goes to the ballast from the power supply (where the brown & blue wire plugs in). I was looking for something like 300V DC and what I found is 8.9 mV. That sounds like the power supply is bad. When I tested the power supply I had all of the light engine chassis removed and all of the plugs disconnected. Is there anything that I am missing that may effect the output power from this plug? I get the same reading with the tv plugged in and unplugged. With this information is it your opinion that the power supply is bad?
Just Sayin!

Jason1976
TV Repair Ninja
TV Repair Ninja
Posts: 286
Joined: Sat Aug 15, 2009 6:34 pm
Location: Harrisburg PA

Re: Samsung HL-S4676S DLP just quit working!

Postby Jason1976 » Sun May 16, 2010 2:15 am

a power supply is a good place to start. check ebay for a used one. also check on discount merchant and on www.samsungparts.com normaly you can find the part number on www.samsungparts then look it up on the other two web pages.


Return to “Samsung Discussion”