Then the other day before I fired it up for the night I did a Lamp Timer reset. That's when I saw the 15,523 hrs on it. Once I came out and fired up it for the night and to catch on some killer movies I have been saving, I noticed the picture was too dark and high contrast. When I switched to the TV feed everything brightened back up. Switched to the HDMI input and I could see the OSD in the upper left corner with the input and resolution dim down to match the bad picture that I am now getting. Switch back to TV and it brightens right up. The OSD for settings and whatnot are bright a vibrant. But anything coming in on an HDMI input goes dark, high contrast and heavy color saturation. This was only with HDMI feeds. Now it's the same across the board. I had to have done something while in the service menu. But since I have been in there many times and know my way around, I don't remember messing anything up. So I went back in and did a Factory Reset, no change. I have been able to get the "Movie" setting, that is usually darker and washed out with a touch of sepia, looking halfway decent, but had to jack up setting that last night I really had crank down. The other picture settings are really dark and whacked out.
So my question is there a service guide or User created document that specifies what the setting values should be in the Service Menu so I can verify if I did indeed change something? I did go in and toggle some settings but no luck.
Any assistance will be greatly appreciated.
Thank you.