Internal Board-to-Board Cabling/Connectors
Posted: Tue Jun 09, 2009 2:31 pm
*This is NOT a request for color wheel, bulb, or ballast replacement instructions*
I have replaced my BP96-00674A color wheel, but in the process severed the 5-pin cabling from the PCB (there are 3 *unmarked* connectors in a row on the top right of the PCB - this is rightmost one). The connector is still in the receptacle on the PCB but is badly mangled from my "tweezing* it out. The wire is still in good shape, though separated from the connector.
My questions are these:
Can this cable/connector be replaced or repaired/soldered?
If so, where can I find resources to replace or repair?
Thanks in advance.
I have replaced my BP96-00674A color wheel, but in the process severed the 5-pin cabling from the PCB (there are 3 *unmarked* connectors in a row on the top right of the PCB - this is rightmost one). The connector is still in the receptacle on the PCB but is badly mangled from my "tweezing* it out. The wire is still in good shape, though separated from the connector.
My questions are these:
Can this cable/connector be replaced or repaired/soldered?
If so, where can I find resources to replace or repair?
Thanks in advance.