Page 1 of 1

New lamp, new color wheel, now what?

Posted: Tue Aug 25, 2009 4:22 am
by dlre1185
model # hd50lpw166yx7, TV is 3 years old. Yes the 5 blinking lights of DOOM are back, after I replaced the lamp, then took to TV repair place, they told me it was a bad color wheel, called RCA, they sent me a new one, put it in, pluged it in, once again 5 blinking lights! What should I attempt to do next, the ballast? I'm already into it, lamp $140, diagnostic $50, and now a color wheel $145! :oops: :x

Re: New lamp, new color wheel, now what?

Posted: Tue Aug 25, 2009 2:03 pm
by mitchkramez
does it blink 5 times and shut off, or blink 5 times repeatedly?

have you pulled out the power supply to look for any puffy capacitors or burn marks around capacitors or any leaking electrolytic?

Re: New lamp, new color wheel, now what?

Posted: Tue Aug 25, 2009 3:29 pm
by dlre1185
Ya, when I plug it in it the power button blinks 5 times then stays on steady, can't turn it off? In the back left hand side I can see a red light, but I don't here any fans going or anything for that matter!

Re: New lamp, new color wheel, now what?

Posted: Wed Aug 26, 2009 7:24 pm
by mitchkramez
That's pretty much exactly what mine did, other than the tv would turn off after the solid light was on for 5 seconds. I'm not sure what that red light is, but mine has the same thing and it's actually inside the inputs cage if you open it up.

I didn't have any fans, nothing made any noise, but as soon as those bad caps were replaced it came right on...