Page 1 of 1

Mitsubishi wd-60638 won't turn on

Posted: Thu Feb 18, 2016 1:15 am
by Rooks
Sooo last Tuesday I heard pop and smelled burning electrical , ordered a new bulb ( Philips not knock off) got it in last night . disconnected the panel and took out the broken bulb and installed a new one.



Plugged unit in factory reset the set via holding power for 10 seconds and pressed the power button. Nothing... rechecked all the connections and tried power again. Stuck my head behind the TV and could hear the low whine of electricity when power button was pressed.



No green light at all set is just dead at this point. So apart from picking random parts to replace what should my next step be?





Danke

Re: Mitsubishi wd-60638 won't turn on

Posted: Mon Feb 29, 2016 4:54 pm
by ChubbsTech
Hello,



It sounds like the ballast is not putting out the proper voltage to ignite your new lamp. If your TV is anywhere near 5 yrs or older this is common.



Regards,