FixYourDLP.com Forums

Ian
Submitted on 2008/10/22 at 1:05am

Hi,
Is the above resetting procedure for LG MW-60SZ12 tvs as well.
Please advise.
Kind regards
Ian

JP Spampinato
Submitted on 2008/10/17 at 2:59am

This worked for my Zenith E44W46LCD LCD HDTV by doing step 5 before 4 and not worrying about the System Menu disappearing. The Lamp Reset comes up fine after 5 seconds.

9904 hours from the factory lamp, WHOOP!

I have not replaced the lamp itself because the picture is still bright and fine. I might not be considered a standard user of a home LCD set, though. I only cycle my TV about once a week because I still believe that the more thermal expansions any electronic components are put through the more they wear out. You could call me old fashioned but in my particular case it’s because there’s always someone awake in our household. It’s a freaking commune here sooo… anywhoo… your mileage will probably vary; my TV is always on.

Either way I wanted to thank you for documenting this because this worked perfectly.

If you replace the DLP lamp out of your Zenith or LG, you will need to reset the counter...otherwise you may get an annoying reminder every few days if you're surpassed the predetermined hour mark.

To Reset:

Ensure the TV is powered on.

1) Press and HOLD the MENU button on the TV
2) Press and HOLD the MENU button on your REMOTE
(hold both these until the service menu pops up 5-10 secs max.)
3) Let go of the REMOTE button first, then release the button on the TV
4) Press and HOLD the ENTER (or OK) button on the TV
5) Press and HOLD the MUTE button on the REMOTE
(hold both until the LAMP LIFE HOURS appears on the screen)
6) Let go of the REMOTE button first, then release the button on the TV
We suggest writing your lamp hours on a peice of masking tape and taping it to the back the TV for future reference.
7) To reset the lamp counter, press SELECT (or the button in the middle of the direction arrove buttons). Hit SELECT a second time to confirm clearing the lamp counter

For certain models, you might have to tweak these steps slightly...offer your inputs!

STEVE
Submitted on 2008/08/19 at 3:52pm

Thanks. My lamp indicator said 8071 hours.
The instructions worked perfectly. On my LG 52SZ8D-UA I had an extra step.

From the service menu I scrolled down to position
Press enter on the TV
Press enter again and hold it down
Press mute on the remote and hold it down
Wait till the lamp life screen pops up
Press enter on the TV
select intilize
Orange light goes out

dmiller
Submitted on 2008/05/13 at 2:46pm

Zenith Z52SZ80
On step 5, release the enter button on the TV while holding down Mute on the remote, press Enter on TV again and the Lamp hour reset will come up.
Piece of Cake