New lamp only stays on 20 secs, constant blink ylw

Moderator: Angel

Post Reply
Chavid
Newbie
Newbie
Posts: 2
Joined: Sat Jul 23, 2011 11:36 pm

New lamp only stays on 20 secs, constant blink ylw

Post by Chavid » Sun Jul 24, 2011 12:24 am

Here's my situation: I've bought two factory replacement lamps...no knock-offs. The first one didn't work at all, but the 2nd one did...sort of. It will flicker until it turns on, then it will turn off after about 20 seconds on average (never get a picture to display when it's on, not even a menu screen, so I'm not sure how I could reset the lamp timer in this case). Keeps doing this for the allotted 8 attempts. Now, I've already replaced the ballast, ballast power supply, door switch, and the lamp temperature sensor, and it's still doing the same thing... flashing yellow with a solid blue power light until the dreaded red light appears. The guide keeps saying the same thing: It's the lamp technology. So, at this point, I'm at a loss. This is so frustrating. :x Any thoughts?
To note: I lost the lamp door cover during a move; however, the door switch has been manipulated to always stay in the 'on' position, which prevents a solid yellow light, and the warning voice from saying 'lamp door is open' . And from my understanding, if it's not 'on'...lamp won't power up at all, which isn't my problem. I never dreamt finding a replacement door (part 75008454) would be so difficult; I've looked everywhere online. I should mention: At start-up, periodically, I do hear a few clicks, like a taser, even after I'd replaced all the hardware mentioned above. I don't hear a high-pitch sound, however, which I've learned should be the color wheel activating...assuming that that description is accurate. I really don't want to sink much more money into it by assuming another replacement piece of hardware will fix the issue. I really just want to know what's definitely causing this problem(s). Please help! :( Thanks! -Chavid

User avatar
grayfox
Jedi Master
Jedi Master
Posts: 1049
Joined: Sat Jun 13, 2009 9:40 pm
Location: Sunny San Diego!
Contact:

Re: New lamp only stays on 20 secs, constant blink ylw

Post by grayfox » Thu Sep 29, 2011 8:07 pm

Hello,
Sometimes the lamps ballast goes out after you replace the lamp. The ballast essentially is responsible for powering up the lamp, since it is the second most popular consumable part in your TV, I would strongly advise you consider replacing it. It is relatively inexpensive and easy to do, there is a guide on this site http://www.fixyourdlp.com/guides/guides.php

Hope this helps!
ImageUnit Foxhound

Post Reply

Return to “Toshiba DLP Discussion”