This form contains information on DLP, LCD Projection and other RPTV issues. Any information about a television device that requires a lamp and a ballast should be created here.
Replaced lamp with Philips bulb but not with OEM housing. Contacts with new housing melted and had to replace ballast and used original OEM housing with the new bulb. Picture is great but after set is on for 2 hours it starts to get intermittent red to green tinting that lasts a few seconds then reoccurs in a few minutes. If the set is shut off for about five minutes it takes about ten minutes for the tinting to return. This happens on all inputs including cable,antenna,dvd. Never had this issue before. No noise is coming from the color wheel when this is happening.
- Posts: 3
- Joined: Mon Dec 29, 2014 9:32 pm
Well it could be a problem related to the colorwheel motor going out or the DMD board sending a faulty signal.
Remember Knowing Is Half The Battle !
- TV Wizard
- Posts: 404
- Joined: Thu Feb 18, 2010 12:53 am
- Location: Santa Ana Ca.
Return to DLP, LCD Projection, and other RPTV
Who is online
Users browsing this forum: No registered users and 2 guests