DLP bulb change mix up

Moderator: Angel

Post Reply
VTRN
Newbie
Newbie
Posts: 1
Joined: Mon Jan 31, 2011 4:33 pm

DLP bulb change mix up

Post by VTRN » Mon Jan 31, 2011 4:45 pm

Im trying to replace the lamp in my samsung DLP Television(lamp BP96-01653A). I took the casing apart and replaced the bulb, but am afraid I may have done it wrong. The code on the TV is still blinking to change the bulb. The bulb is marked top, but which is the top of the casing. I put it in as if the top was the top when I pulled it out of the TV, but other places online it shows it with the casing the other way. There are two plug in prongs on the casing which to me are on the bottom. This apparently is crucial in order to figure out which wire goes to which spot on the bulb. Pleas help.
Thanks.

User avatar
grayfox
Jedi Master
Jedi Master
Posts: 1049
Joined: Sat Jun 13, 2009 9:40 pm
Location: Sunny San Diego!
Contact:

Re: DLP bulb change mix up

Post by grayfox » Sun Feb 06, 2011 9:11 pm

Hello,
Do not worry about the wires and connector, this is an A/C (alternating current) lamp so there is no polarity. as long as you have the correct lamp and it is of brand name (Philips or Osram) you should be fine. This might be an issue with your ballast. Have you reset the lamp hour timer if your TV has one?
ImageUnit Foxhound

Post Reply

Return to “All About Lamps”