MITSUBISHI 915B403001 How To Guide Replacement DLP Lamp Guide

Click below to buy this lamp now:

Lowest Prices Anywhere!

Compatible TV Models: WD-60735, WD-60C8, WD-65735, WD-65736, WD-65835, WD-65C8, WD-73735, WD-73736, WD-73835, WD-73C8, WD-73C9, WD-65C9, WD-60C9, WD-82737, WD-73737, WD-65737, WD-60737, WD-82837, WD-73837, WD-65837.

NORMAL DISCLAIMER:
— Do NOT purchase generic brand lamps such as LTI, APO or third-party manufacturers. These lamps were NOT engineered with and for your TV…only your Philips lamp has been engineered to work flawlessly and output the best possible color. Above that, it just doesn’t make sense to choose an aftermarket lamp for a $5-$10 difference (and in many cases they are more expensive!!).

Be a smart consumer and shop around, do your research! Discount-Merchant.com promises to be the low price leader in all Projection Lamps they carry…if this is not true, let us know and we’ll fix it!

Tools Required: 1 Standard Philips screwdriver, & A new lamp.

Time Required: About 15 minutes.

Abstract: This guide is being published to show how easy it is to replace your original MITSUBISHI 915B403001 Lamp.

NOTE: We recommend you to use latex gloves when handling the new bulb, to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

	Mitsubishi 915B403001 Lamp casing			1.- Start by locating and removing the screw securing the connector to the plastic enclosure.
	2.- Carefully but firmly lift the top piece of the enclosure from the bottom one.			3.- Now unscrew the front connector terminal from the old lamp like so.
	4.- Proceed to uninstall the first of four metal lamp holders with your screwdriver.			5.- There are two metal lamp holders in the front.
	6.- The third and fourth metal lamp holders are adjacent to the enclosure side base.			Be sure to position the screwdriver straight to prevent from damaging any components.
	8.- Now remove the last screw that holds the second connector cable to the back lamp terminal.			A.- After removing your old bulb take out your new one, wich will look something like this.
	B.-Insert the screw holding the back lamp terminal to the cable connector (since there is no polarity either one will do).			C.-Reinstall the metal clip to the back of the lamp, using your Phillips screwdriver.
	D.- Continue with the second one closet o the enclosure base.			E.- Screw back the third metal lamp holder.
	F.- Make sure not to secure it to tight, so to not damage the enclosure.			G.- Insert the last screw that secures the connector cable to the front terminal of the lamp.
	H.- Place back the top piece of the enclosure until it snaps on booth sides.			I.- Reinstall the screw holding the connector to the enclosure.
	J.- Congratulation, your finished!

IMPORTANT: After installing the replacement bulb, you should wipe it with a clean cloth to avoid any dirt or oil. Our hands are naturally oily…this could reduce considerably the life span of the new lamp.

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it

Click below to buy this lamp now:

Lowest Prices Anywhere!

Lamp MITSUBISHI 915B403001 How-To Replacement Guide