Mitsubishi DLP Lamp 915P043010 (132W Matsushita or Panasonic lamp) How To Guide Replacement DLP TV Lamp Guide

For Part Number: Mitsubishi 915P043010 (Sealed replacement lamp for DLP televisions, SMALL lamp, SEALED lamp at 132W)

Tools Required: Philips and flathead screwdrivers, a pair of pliers, and a new lamp.

Time Required: About 15 minutes

Abstract: This guide is being published to show how easy it is to replace your original Mitsubishi 915P043010, sealed lamp using an OEM 132W Matsushita (Panasonic) replacement lamp.

Click below to buy this lamp now:

Lowest Prices Anywhere!

NORMAL DISCLAIMER:

Be a smart consumer and do your research! Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry… if this is not true, let us know and we’ll fix it!

Necessities:

1. A Phillips screwdriver and a flathead screwdriver
2. A Pair of Pliers
3. A new Matsushita Lamp
4. 15 minutes of your time

NOTE: The bulb should be handled with a clean lint-free cloth at all times to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

Here is the Mitsubishi DLP Lamp and lamp enclosure guide, remember you can click on any image to enlarge!

	This should be the enclosure you're working with...			This is the face of the lamp.
	You'll need to remove the clamps holding the lamp in place.			To do this, use needle nose pk
	There's one on the other side too.			Keep the clamps safe because you'll need them again later.
	You now can remove the lamp and ballast wires from the housing.			It should come off easily after you've removed all the screws.

	Remove the ballast wires from the terminal.			Some lamps will come with a set of these wires already attached...

				Snap the clips back in place...
	For both sides of the lamp.			Examine the
	Here, you can see the connector to the ballast.

				Snap the wire clamp into place...

				Re attach the clamp to hold the lamp into place.
				If you've followed the photos and the instructions, you should be done!

IMPORTANT: The bulb should be handled with a clean cloth at all times to avoid any dirt or oil. Our hands are naturally oily…this is a no-no for these lamps. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Click below to buy this lamp now:

Lowest Prices Anywhere!

Mitsubishi DLP Lamp 915P043010 How-To Replacement Guide