Sony XL-2500 How To Guide Replacement DLP TV Lamp Guide

Click below to buy this lamp now:

Lowest Prices Anywhere!

Compatible TV Models: XL-2500U, XL-2500E, XL-2500J, XL-2500C, XL2500U, XL2500E, XL2500J, XL2500C, F93089000, F-93089000.

Assembly part numbers: KDF46E3000, KDF50E3000.

NORMAL DISCLAIMER:
— Do NOT purchase generic brand lamps such as LTI, APO or third-party manufacturers such as OSRAM.

These lamps were NOT engineered with and for your TV…only your Philips lamp has been engineered to work flawlessly and output the best possible color. Above that, it just doesn’t make sense to choose an aftermarket lamp for a $5-$10 difference (and in many cases they are more expensive!!). Be a smart consumer and do your research! Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Tools Required: Standard Philips or Flathead screwdrivers, Pair of Pliers, A new lamp.

Time Required: About 15 minutes.

Abstract: This guide is being published to show how easy it is to replace your original Sony XL-2500 Lamp.

NOTE: The bulb should be handled with a clean lint-free cloth at all times to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lint-free cloth before reinstalling your lamp…

	Sony XL-2500 Lamp casing			1.-Let’s start by removing a screw located under the cables to loosen them up from the enclosure.
	2.-The connectors will come off with its small metal plate, leave it as it is.			3.-Now remove the screws located on the side of the enclosure.
	4.-And locate two small clips on the side, press on them and pull back the enclosure.			5.-This will free the back of the lamps casing that looks like this.
	6.-Now remove the two cables connected to the lamp by removing the screw and nut.			7.-And now the casing is split in two.
	8.-Now the lamp should be exposed, and revile some small metal clips on the corners of the base.			9.-Remove from one of the corners a clip holding the lamp in place, and loosen the other one on the other side.
	10.-After removing the bulb, the base of the lamp will look like this.			11.-Now grab your new bulb, and get ready to install it. Be very careful when handling the bulb, it’s very fragile.
	A.-After placing it in the base, screw back the metal clips to hold it in place.			B.-Now reassemble the lamp enclosure that was divided in two.
	C.-When connecting them you’ll hear a click that means that it has been successfully connected.			D.-Insert the last screw to secure the cable connectors to the enclosure.
	E.-Insert the last screw to secure the cable connectors to the enclosure. .			F.-And you’re finished.

IMPORTANT: After installing the replacement bulb, you should wipe it with a clean cloth to avoid any dirt or oil. Our hands are naturally oily…this could reduce considerably the life span of the new lamp.

Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!

Click below to buy this lamp now:

Lowest Prices Anywhere!

Sony DLP Lamp XL-2500 How-To Replacement Guide