Replace the Canon LV-X300 ST projector lamp

How to install a new Canon LV-X300 ST projector lamp

When it’s time to replace the Canon LV-X300 ST projector lamp you’ll see a lamp replacement icon appear on screen and the LAMP REPLACE indicator will light orange. Replace the lamp immediately. When the projector is in operation, the duration (in hours) of lamp usage is automatically calculated by the built-in timer.

Buy this lamp on Amazon sold by these authorized dealers:

 

Watch for the warning signs on screen:

Canon_LV-X300 ST_projector_Canon LV-LP38_replacement_lamp_warnings

First warning: The lamp has been in operation for 4500 hours. Install a new lamp

for optimal performance. If the Canon LV-X300 ST projector is operating in Economic mode, you can use the the to 4950 hour.

Second warning: The lamp has been in operation for 4950 hours. Get your authentic replacement projector lamp ready .

Third warning: The lamp has been in operation for 5000 hours. It is strongly recommended that you replace the lamp

Final Warning: The lamp MUST be replaced before the projector will operate

Install the projector lamp

Your Canon LV-X300 ST projector uses the Canon LV-LP38 projector lamp model. Before replacing the lamp follow these safety instructions:

  • Unplug the electrical cord on the Canon LV-X300 ST so there is no chance the projector could get turned on during the installation.
  • The Canon LV-X300 ST operates under high temperatures so give it at least one hour to cool down before opening the projector to change the projector lamp.

Canon_LV-WX300_projector_Canon LV-LP38_replacement_lamp_remove_cover

Canon_LV-X300 ST_projector_Canon LV-LP38_replacement_lamp_remove

  • Loosen the screw holding the Canon LV-LP38 projector lamp cover in place.

    Lift the lamp cover up. Do not turn the power on with the lamp cover removed.

Canon_LV-WX300_projector_Canon LV-LP38_replacement_lamp_replace

 

Canon_LV-WX300_projector_Canon LV-LP38_replacement_lamp_install

  • Replace the lamp assembly with a new Canon LV-LP38 projector lamp. Be careful not to touch the actual bulb as oil from your fingers can leave black marks on the lamp.
  • Close the lamp cover

 

Resetting the lamp timer counter

After replacing the Canon LV-LP38 projector lamp, you’ll need to reset the lamp. To reset:

Canon_LV-WX300_projector_Canon LV-LP38_replacement_lamp_reset_timer

  • Restart the projector.
  • Open the On-Screen Display (OSD) menu.
  • Go to the SYSTEM SETUP: Advanced>Lamp Settings menu.
  • Press OK/IMAGE. The Lamp Settings page is displayed. Press to highlight/ Reset lamp timer and press OK/IMAGE.
  • A warning message is displayed asking if you want to reset the lamp timer. Highlight Reset and press OK/IMAGE . The lamp time will be reset to ‘0’.

Learn how to prolong lamp life with Top tips for extending projector lamp life.

 

Tagged with: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*

Time limit is exhausted. Please reload CAPTCHA.

This site uses Akismet to reduce spam. Learn how your comment data is processed.